Element 2WD L4-2.4L (2003)
7. Pull the latch (A) out until you can disconnect the inner handle rod (B), then disconnect the rod.
8. Remove the latch from the hole in the door. Take care not to bend the rods.
9. Pull the lock rod protector (A) upward, then remove the protector from the latch (B).
10. Install the latch in the reverse order of removal, and note these items:
-
Make sure the actuator connectors are plugged in properly, and each rod is connected securely.
-
Make sure the door locks and opens properly.
-
When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its perimeter.
