Element 2WD L4-2.4L (2003)
3. Before connecting a new fuel tube/quick-connect fining assembly (A), remove the old retainer from the mating line.
4. Align the quick-connect fittings with the line (A), and align the retainer locking tabs (B) with the connector grooves (C). Then press the quick
connect fittings onto the line until both retainer tabs lock with a clicking sound.
NOTE: If it is hard to connect, put a small amount of new engine oil on the line end.
5. Make sure the connection is secure and that the tabs are firmly looked into place; check visually and by pulling the connector.
6. Reconnect the negative cable to the battery, and turn the ignition switch ON (II). The fuel pump will run for about 2 seconds, and fuel pressure
will rise. Repeat two or three times, and check that there is no leakage in the fuel supply system.
