Odyssey L4-2.2L SOHC (1995)
Distributor: Service and Repair
Installation
NOTE: Before you install the Distributor, bring the No. 1 Piston to compression stroke Top Dead Center (TDC).
1. Coat a new 0-ring with Engine oil, then install it.
2. Slip the Distributor into position.
NOTE: The Lugs on the end of the Distributor and their mating grooves in the Camshaft end are both offset to eliminate the possibility of
installing the Distributor 180° out of time.
3. Install the Mounting Bolts, and tighten them lightly.
4. Connect the 2 P and 8 P Connectors to the Distributor.
5. Connect the Ignition Wires as shown.
6. Set the Timing with a Timing Light.
7. After setting the Timing, tighten the Mounting Bolts.