Odyssey L4-2.2L SOHC (1995)
Air Bag: Service and Repair
Passenger Airbag Replacement
After a collision in which the airbags were deployed, the airbag assemblies and the SRS unit must be replaced.
Store a removed airbag assembly with the pad surface up. If the airbag is improperly stored face down, accidental deployment could propel the unit with
enough force to cause serious injury.
CAUTION
-
Do not install used SRS parts from another car. When repairing, use only new SRS parts.
-
Carefully inspect the airbag assembly before you install it. Do not install an airbag assembly that shows signs of being dropped or
improperly handled, such as dents, cracks or deformation.
-
Always keep the short connectors (RED) on the airbags when the harness is disconnected.
-
Do not disassemble or tamper with the airbag assembly.
1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the radio's preset buttons.
2. Disconnect the battery negative cable, then disconnect the positive cable from the battery, and wait at least three minutes.
3. Connect the short connectors (RED):
-
Remove the dashboard compartment, then remove the short connector (RED) from it's holder.
-
Disconnect the 3P connector between the front passenger's airbag and SRS main harness, then connect the short connector (RED) to the airbag
side of the connector.
4. Remove the airbags:
