honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Driver Airbag Replacement|Page 8255 > < Driver Airbag Replacement|Page 8253
Page 1
background image

Air Bag: Service and Repair
Airbag Assembly Disposal and Deployment

Damaged Airbag/Tensioner Special Procedure

If an airbag cannot be deployed, it should not be treated as normal scrap; it should still be considered a potentially explosive device that can cause
serious injury

1. If installed in a car, follow the Airbag Assembly removal procedure.

2. In all cases, make a short circuit by twisting together the two airbag inflator wires.

3. Package the airbag in exactly the same packaging that the new replacement part came in.

4. Mark the outside of the box "DAMAGED AIRBAG NOT DEPLOYED" so it does not get confused with your parts stock.

5. Contact your Honda District Service Manager for how and where to return it for disposal.

Driver's Air Bag

Before scrapping any airbags (including those in a whole car to be scrapped), the airbags must be deployed. If the car is still within the warranty period,
before you deploy the airbags, the Honda District Service Manager must give approval and/or special instructions. Only after the airbags have been
deployed (as the result of vehicle collision, for example), can they be scrapped. If the airbags appear intact (not deployed), treat them with extreme
caution. Follow this procedure:

Deploying the Airbags: In-car

NOTE: If an SRS car is to be entirely scrapped, its airbags should be deployed while still in the car. The airbags should not be considered as salvageable
parts and should never be installed in another car.

WARNING: Confirm that each airbag assembly is securely mounted; otherwise, severe personal injury could result from deployment.

1. Make sure you have the anti-theft code for the radio then write down the frequencies for the radio's preset buttons.

2. Disconnect the battery negative cable, then disconnect the positive cable.

3. Confirm that the special tool is functioning properly by following the check procedure on the label of the tool set box.

4. Remove the access panel, then disconnect the 3P connector between the driver's airbag and the cable reel.

Driver Airbag Replacement|Page 8255 > < Driver Airbag Replacement|Page 8253