Odyssey L4-2.2L SOHC (1995)
Air Bag Control Module: Service and Repair
CAUTION:
-
Before disconnecting any part of the SRS wire harness, connect the short connectors (RED) to the airbags.
-
During installation or replacement, do not bump (impact wrench, hammer etc.) the area near the SRS unit.
-
Do not damage the SRS unit terminals or connectors.
-
Do not disassemble the SRS unit; it has no serviceable parts.
-
Store the SRS unit in a clean, dry area.
-
Do not use any SRS unit which has been subjected to water damage or shows signs of being dropped or improperly handled, such as
dents, cracks or deformation.
1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the radio's preset buttons.
2. Disconnect the battery negative cable, then disconnect the positive cable from the battery, and wait at least three minutes.
3. Connect the short connector (RED) to the airbags.
4. Remove the heater lower cover from the center console (driver and front passenger side).
5. Disconnect the SRS main harness 18P connector from the SRS unit.
