Odyssey L4-2.2L SOHC (1995)
Clockspring Assembly / Spiral Cable: Service and Repair
Driver's Side
Store a removed airbag assembly with the pad surface up. If the airbag is improperly stored face down, accidental deployment could propel the unit with
enough force to cause serious injury.
CAUTION:
-
Carefully inspect the airbag assembly before installing it. Do not install an airbag assembly that shows signs of being dropped or
improperly handled, such as dents, cracks or deformation.
-
Always keep the short connectors on the airbag connectors when the harness is disconnected.
-
Do not disassemble or tamper with the airbag assembly.
1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the radio's preset buttons.
2. Disconnect the battery negative cable, then disconnect the positive cable from the battery, and wait at least three minutes.
3. Connect the short connectors (RED):
-
Remove the access panel from the steering wheel, then remove the short connector (RED) from the panel.
-
Disconnect the 3P connector between the driver's airbag and cable reel, then connect the short connector (RED) to the airbag side of the connector.
4. Make sure the wheels are aligned straight ahead.
5. Remove the dashboard lower cover and knee bolster.
6. Remove the driver's airbag assembly from the steering wheel (two T30 Torx bolts), then remove the steering wheel bolt.
