Odyssey L4-2.2L SOHC (1995)
14. Install the regulator.
NOTE: Make sure the connector is connected properly.
15. Install the glass on the regulator, and insert it into the rear lower channel, then temporarily tighten the bolts and nut of the rear lower channel.
16. Raise the glass, then install the center lower channel.
17. Tighten the bolts and nut of the rear lower channel securely.
18. Pull the outer weatherstrip away, then install the outer cover as shown.
NOTE: Fit the outer cover securely.
19. Roll the glass up and down to see if it moves freely without binding. Also make sure that there is no clearance between the glass and glass run
channel when the glass is closed. Adjust the position of the glass as necessary.
20. Make sure the door harness and connectors are fastened correctly on the door.
21. Disconnect the power window switch from the door harness.
22. Install the plastic cover and all removed parts.
23. Install the door panel.
