honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Audio System - Remote Controls Don't Work Properly|Page 7051 > < Audio System - Remote Controls Don't Work Properly|Page 7049
Page 6
background image

17.

Position the cancel sleeve on the combination switch assembly so that the projections on the sleeve are aligned vertically.

18.

Carefully reinstall the cable reel with the original screws.

19.

1999-01 models: Reconnect the SRS main harness 2P connector and cable reel 2P connector, and then plug the dashboard wire harness 4P
connector and cable reel 4P connector together.

2002-04 models: Reconnect the SRS main harness 4P connectors and cable reel 4P connectors.

20.

Reinstall the upper and lower steering column covers with the original screws.

21.

If needed, center the cable reel by first rotating the reel clockwise until it stops, and then rotating it counterclockwise (approximately two and a
half turns) until the arrow mark on the reel label points straight up.

22.

1999-01 models: Line up the paint marks, and reinstall the steering wheel. Torque the nut to 49 N.m (36 lb-ft).

2002-04 models: Line up the paint marks, and reinstall the steering wheel. Torque the bolt to 36 N.m (28 lb-ft).

23.

1999-01 models: Plug in the connectors for the remote audio and cruise control switches.

2002-04 models: Plug in the connectors for the horn, remote audio, and cruise control switches.

24.

1999-01 models: Reconnect the horn switch 1P connector, and reinstall the driver's airbag. Torque the Torx bolts to 9.8 N.m (7.2 lb-ft), and
reinstall the steering wheel covers.

2002-04 models: Reinstall the driver's airbag. Torque the Torx bolts to 9.8 N.m (7.2 lb-ft).

25.

Reinstall the lower dashboard cover.

26.

1999-01 models: Reconnect the 2P cable reel connector to the driver's airbag 2P connector.

2002-04 models: Reconnect the 4P cable reel connector to the driver's airbag 4P connector.

27.

Reinstall the access panel.

28.

Reconnect the battery negative cable.

29.

Do the idle learn procedure.

^

Make sure all electrical items are turned off, then start the engine.

^

Let the engine reach its normal operating temperature (the cooling fan cycles twice).

^

Let the engine idle (throttle fully closed and with all electrical items off) for 10 minutes.

30.

2003-04 models: Initialize the driver's window auto-up feature.

^

Turn the ignition switch to ON (II).

^

Make sure the driver's window is fully closed.

Audio System - Remote Controls Don't Work Properly|Page 7051 > < Audio System - Remote Controls Don't Work Properly|Page 7049