Odyssey V6-3.5L (2003)
8. With the control unit still disconnected, make these input tests at the connector and fuse/relay box socket.
-
If any test indicates a problem, find and correct the cause, then recheck the system.
-
If all the input tests prove OK, go to step 9.
9. Reconnect the passenger's multiplex control unit to the fuse/relay box, and perform the following input tests at the appropriate connectors on the
back of the fuse/relay box.
-
If any test indicates a problem, find and correct the cause, then recheck the system.
-
If all the input tests prove OK, go to step 10.
Door Multiplex Control Unit:
10. Remove the driver's door panel and disconnect the 20P connector from the door multiplex control unit.
11. Inspect all connector and socket terminals to be sure they are making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, go to step 12.
12. Reconnect the connectors to the door unit, and make the input test at the connector.
-
If a test indicates a problem, find and correct the cause, then recheck the system.
