Odyssey V6-3.5L (2003)
14. Keep the vehicle at a steady speed between 50 - 70 mph (80 - 114 kph), without moving the accelerator pedal, for about 1 minute.
15. Stop the vehicle (do not stop the engine).
16. Repeat step 14 and 15 two more times.
17. Check the readiness code with the scan tool.
HO(2)S Monitor Code
NOTE:
-
Do not turn the ignition switch OFF.
-
When the battery negative cable is disconnected, all readiness codes are cleared.
-
When PCM is cleared with the OBD II scan tool or Honda PGM Tester, all readiness code or cleared.
Required condition:
Ambient temperature between 20 - 95 °F (-7 - 35°C).
1. Connect the scan tool to the Data Link Connector.
2. Start the engine, and hold it at 3,000 rpm with no load (in Park or neutral) until the radiator fan comes on.
3. Let the engine idle for 5 seconds.
4. Drive at a steady speed between 50 - 62 mph (80 - 100 kph) for about 2 minutes.
5. With the transmission in (D5) position, decelerate from 62 mph (100 kph) by completely releasing the throttle for at least 5 seconds. If the engine
is stopped during this procedure, repeat steps 4 and 5.
6. Check the readiness code with the scan tool.
HO(2)S Heater Monitor
NOTE: When the battery negative cable is disconnected, all readiness codes are cleared.
1. Connect the scan tool to the Data Link Connector.
2. Start the engine, and let idle for 10 minutes.
3. Check the readiness code with the scan tool.