honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Symptom Related Diagnostic Procedures|Page 3099 > < Symptom Related Diagnostic Procedures|Page 3097
Page 6
background image

relay and the rear heater-A/C passenger's control panel.

Rear Blower Motor Middle Speed Circuit Troubleshooting

1. Remove the rear blower unit.

2. Remove the rear blower motor middle relay, and test it.

Is the relay OK?

YES-Go to step 3.

NO-Replace the rear blower motor middle relay.

3. Disconnect the rear blower resistor.

4. Measure the resistance between the No.1 and No.4 terminals of the rear blower resistor.

Is there approximately 1.4 ohm?

YES-Go to step 5.

NO-Replace the rear blower resistor.

5. Check for continuity between the No.4 terminal of the rear blower resistor 5P connector and the No.2 terminal of the rear blower motor middle

relay 5P socket.

Is there continuity?

YES-Go to step 6.

NO-Repair open in the wire between the rear blower resistor and the rear blower motor middle relay.

Symptom Related Diagnostic Procedures|Page 3099 > < Symptom Related Diagnostic Procedures|Page 3097