honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Symptom Related Diagnostic Procedures|Page 3101 > < Symptom Related Diagnostic Procedures|Page 3099
Page 8
background image

11. Check for continuity between the No.3 terminal of the rear blower motor middle relay 5P socket and the No. 3terminal of the rear heater-A/C main

switch 10P connector, and between the No.3 terminal of the rear blower motor middle relay 5P socket and the No.3 terminal of the rear heater-A/C
passenger's control panel 10P connector.

Is there continuity?

YES-Test the rear heater-A/C main switch  and the rear heater-A/C passenger's control panel. Replace the switch as needed.

NO-Repair open in the wire between the rear blower motor middle relay and the rear heater-A/C main switch, or between the rear blower motor
middle relay and the rear heater-A/C passenger's control panel.

Rear Blower Motor High Speed Circuit - Hot/Cold

1. Remove the rear blower unit.

2. Remove the rear blower motor main relay, and test it (Power relay).

Is the relay OK?

YES-Go to step 3.

NO-Replace the rear blower motor main relay.

3. Disconnect the rear blower resistor.

4. Measure the resistance between the No.1 and No.2 terminals of the rear blower resistor.

Is there approximately 0.6 ohm?

YES-Go to step 5.

NO-Replace the rear blower resistor.

Symptom Related Diagnostic Procedures|Page 3101 > < Symptom Related Diagnostic Procedures|Page 3099