Odyssey EX V6-3.5L (1999)
Does the ignition key light blink and beeper beep?
YES-The circuit is OK. Refer to the test(s) for that individual system.
NO-Go to step 15.
In each table shown, the control unit is followed by a list of circuits that it can check in Mode 2.
15. Check two or three more circuits listed for that control unit.
Does the ignition key light blink and the beeper beep far each circuit?
YES-The additional circuits are OK. Repair the short or open in the circuit that failed the test in the preceding step.
NO-Multiple failed circuits can mean that the control unit has failed, but without triggering a DTC. Test a few more circuits. If they also fail,
substitute a known-good control unit, then recheck. If the system works properly, the original control unit is faulty; replace it. If there is still a
malfunction, substitute a known-good control unit for the next most likely faulty control unit, then recheck. If the system works properly, that
control unit is faulty; replace it.
