Odyssey EX V6-3.5L (1999)
Shift Cable: Adjustments
Shift Cable Adjustment
SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the SRS section before performing
repairs or service.
1. Remove the steering column covers.
2. Shift the transmission into [N] position.
3. Remove the nut (A) securing the shift cable end (B), then separate the shift cable (C) from the shift lever assembly (D).
4. Push the shift cable until it stops, then release your hand. Pull the shift cable back two steps so that the shift lever position is in [N].
5. Turn the ignition switch ON (II), and verify that the [N] position indicator light comes on.
6. Insert a 6.0 mm (0.24 inch) pin (A) into the positioning hole (B) on the detent plate through the positioning hole (C) on the control bracket.