Odyssey LX V6-3.5L (2000)
release the spring against the end of the brush.
NOTE: To seat new brushes, slip a strip of #500 or #600 sandpaper, with the grit side up, between the commutator and each brush, and smoothly
rotate the armature. The contact surface of the brushes will be sanded to the same contour as the commutator.
16. Install the starter end cover (A) to retain the brush holder (B).
Overrunning Clutch Inspection
17. Slide the overrunning clutch along the shaft. Replace it if it does not slide smoothly.
18. Rotate the overrunning clutch (A) both ways. If it does not lock in either direction or it locks in both directions, replace it.
19. If the starter drive gear (B) is worn or damaged, replace the overrunning clutch assembly; the gear is not available separately.
Check the condition of the torque converter ring gear if the starter drive gear teeth are damaged.
20. Reassemble the starter in reverse order of disassembly.
