Passport EX 4WD V6-3165cc 3.2L DOHC MFI (2001)
Brake Rotor/Disc: Testing and Inspection
Rear Disc Brake Rotor
Inspection
In the manufacturing of the brake rotor, all the tolerances regarding surface finish, parallelism and lateral runout are held very closely. Maintaining
these tolerances provides the surface necessary to assure smooth brake operation.
Checking Lateral Runout
1. Adjust the wheel bearing correctly.
2. Attach the dial indicator accordingly so that the stem contacts the rotor surface to approximately 29 mm (1.14 inch) from the rotor edge.
3. Rotate the rotor one complete turn and inspect for signs of lateral runout. Lateral runout should not exceed 0.13 mm (0.005 inch).
Rear Drum (In Disc) Inside Diameter Check
Check the rear drum inside diameter by measuring at more than two portions as shown in the illustration. If the inside diameter is greater than the
limit, replace the rear rotor.
Standard: 210.0 mm (8.27 inch)
Limit: 211.4 mm (8.32 inch)