Passport EX 4WD V6-3165cc 3.2L DOHC MFI (2001)
10. Remove hold-down spring and cup (3) and hold-down pin (16).
11. Remove trailing shoe assembly (7) with parking brake lever (16).
12. Remove parking brake cable from parking brake lever (11).
13. Remove retainer (14), wave washer (13), and parking brake lever (11).
Brake Lining Inspection
Check the shoe assemblies for wear by removing brake drum.
Replace the shoe assemblies, if lining thickness is less than 1.0 mm (0.039 inch).
The shoe assemblies have a wear indicator that makes a noise when the linings wear to a degree where replacement is required.
Minimum limit: 1.0 mm (0.039 inch)
Installation
1. Apply grease lightly to back place A.
2. Install parking brake lever (11), wave washer (13), and retainer (14).
3. Install trailing shoe assembly (7) with parking brake lever (16).
4. Install the parking brake cable to parking brake lever (11).
5. Install hold-down pin (16) and hold-down spring and cup (3).
6. Install upper (inner) return spring (9).
7. Install leading shoe assembly (8) with upper (inner) return spring (9).