Passport EX 4WD V6-3165cc 3.2L DOHC MFI (2001)
4. Measure dimension (4).
Dimension (4) (Standard): -0.1 - 0.1 mm (-0.0039 - 0.0039 inch)
5. If dimension (4) is out of the standard range, adjust push rod using the Push Rod Support J-39241.
6. Mount plate and seal assembly in vacuum booster front shell. Then install the retainer.
7. Install vacuum booster fixing nut and tighten the specified torque.
Torque: 15 Nm (11 ft. lbs.)
8. Install yoke clevis.
9. Connect vacuum hose and make sure that the arrow on the hose points in the direction of the engine.
10. Install master cylinder.