Passport EX 4WD V6-3165cc 3.2L DOHC MFI (2001)
Crankshaft Main Bearing Seal: Service and Repair
Removal
1. Remove transmission assembly.
2. Remove flywheel.
3. Remove rear oil seal using a seal remover.
NOTE: Take care not to damage the crankshaft or oil seal retainer when removing oil seal.
Installation
1. Apply engine oil to oil seal lip and install oil seal using J-39201.
2. Install flywheel.
-
Clean tapped holes in the crankshaft.
-
Remove oil on the crankshaft and flywheel mounting surface.
-
Tighten fixing bolts to the specified torque.
NOTE: Do not reuse the bolts and do not apply oil or thread lock to the bolts.
Torque: 54 Nm (40 ft. lbs.)
3. Install transmission.
CAUTION: When assembling the engine and transmission, confirm that dowels have been mounted in the specified positions at the engine
side.