Passport EX 4WD V6-3165cc 3.2L DOHC MFI (2001)
Exhaust Manifold: Service and Repair
Exhaust Manifold LH
Removal
1. Disconnect battery ground cable.
2. Disconnect O2 sensor connector.
3. Remove exhaust front pipe three stud nuts from exhaust side and two bolts from rear end of exhaust front pipe
4. Remove exhaust manifold eight fixing nuts and remove exhaust manifold from the engine.
Installation
1. Install exhaust manifold and tighten exhaust manifold fixing nuts to the specified torque with new nuts.
Torque: 57 Nm (42 ft. lbs.)
2. Install exhaust front pipe and tighten three stud nuts and two bolts to the specified torque.
Torque:
Stud nuts: 67 Nm (49 ft. lbs.)
Bolts: 43 Nm (32 ft. lbs.)
3. Reconnect O2 sensor connector.