Passport EX 4WD V6-3165cc 3.2L DOHC MFI (2001)
2) Tighten the filter by turning it clockwise seven numbers from the marked point. For example, if a mark is made under the number 2 when the
rubber seal is seated, the filter should be tightened until the number 1 comes up to the marked point.
5. After installation, fill the engine with oil up to the specified level, run the engine for more than three minutes, then check for oil leakage.
CAUTION: Using any procedure other than those shown could result in serious engine damage due to oil leakage.
Replacement M/T With ATTS:
WARNING: Be careful when loosening the drain plug while the engine is hot. Burns can result because the oil temperature is very high.
1. Remove the oil filter with the special tool.
2. Inspect the threads and rubber seal on the new filter. Wipe off seat on the engine block. Apply a light coat of oil to the filter rubber seal.
NOTE: Use only filters with a built-in bypass system.
3. Install the oil filter by hand.