Passport EX 4WD V6-3165cc 3.2L DOHC MFI (2001)
4. Secure the gasket and the throttle body with the four bolts.
-
The vacuum lines must be properly routed under the throttle body before tightening the mounting bolts.
Tighten
-
Tighten the throttle body mounting bolts to 10 N.m (87 lb.in).
5. Install the coolant lines.
6. Connect all the vacuum lines.
7. Install the intake. air duct.
8. Tighten the intake air duct clamp.
9. Connect all the electrical connectors:
-
Throttle position (TP) sensor.
-
Intake air temperature (IAT) sensor. Refer to Intake Air Temperature Sensor.
10. Install the accelerator cable assembly. Refer to Accelerator Cable in Engine Speed Control System.
11. Fill the cooling system. Refer to Cooling System.
12. Install the negative battery cable.