Passport EX 4WD V6-3165cc 3.2L DOHC MFI (2001)
The following procedure requires use of J-42986 Supplemental Restraint System (SRS) Deployment Harness with the appropriate pigtail adapter. The
procedure also requires the use of J-41497 Driver Side SRS Deployment Fixture. Do not attempt this procedure without J-42986 and fixture J-41497.
WARNING: FAILURE TO FOLLOW PROCEDURES IN THE ORDER LISTED MAY RESULT IN PERSONAL INJURY. NEVER
CONNECT DEPLOYMENT HARNESS TO ANY POWER SOURCE BEFORE CONNECTING DEPLOYMENT HARNESS TO THE
DRIVER AIR BAG ASSEMBLY. DEPLOYMENT HARNESS SHALL REMAIN SHORTED AND NOT BE CONNECTED TO A POWER
SOURCE UNTIL THE AIR BAG IS TO BE DEPLOYED. THE AIR BAG ASSEMBLY WILL IMMEDIATELY DEPLOY THE AIR BAG
WHEN A POWER SOURCE IS CONNECTED TO IT. WEAR SAFETY GLASSES THROUGHOUT THIS ENTIRE DEPLOYMENT AND
DISPOSAL PROCEDURE.
NOTE: This information applies only to driver air bag assembly Refer to "Deployment Outside Vehicle (Passenger Air Bag Assembly)" for information
on passenger air bag assembly scrapping.
1. Turn ignition switch to "LOCK", remove key and put on safety glasses.
2. Inspect J-41434 SRS Deployment Harness and appropriate pigtail adapter for damage. If harness or pigtail adapter is damaged, discard and obtain
a replacement.
3. Short the two SRS deployment harness leads together by fully seating one banana plug into the other. SRS deployment harness shall remain
shorted and not be connected to a power source until the air bag is to be deployed.