Passport EX 4WD V6-3165cc 3.2L DOHC MFI (2001)
INSPECTION AND REPAIR
Make necessary parts replacement if wear, damage, corrosion or any other abnormal conditions are found through inspection.
-
Inspect the lower end boot for damage or grease leak. Move the ball joint to confirm its normal movement.
-
Inspect screw/taper area of ball for damage.
-
If any defects are found by the inspections, replace the ball joint assembly with a new one.
-
After moving the ball joint 4 or 5 times, attach nut then measure the preload.
Starting torque: 0.5 - 3.2 Nm (0.4 - 2.4 ft. lbs.)
If the limits specified are exceeded, replace the ball joint assembly.
INSTALLATION
1. Install upper ball joint.
2. Install bolt and nut, then tighten them to the specified torque.
Torque: 57 Nm (42 ft. lbs.)
3. Install nut and cotter pin, then tighten the nut to the specified torque with just enough additional torque to align cotter pin holes. Install new cotter
pin.
Torque: 98 Nm (72 ft. lbs.)