Passport EX 4WD V6-3165cc 3.2L DOHC MFI (2001)
^ If the flat punch doesn't poke a hole in any of the X-marked areas on the frame, go to STAGE 2 REPAIR.
^ * If the flat punch pokes a hole in any of the X-marked areas, or if there are pre-existing holes in the frame above the lower trailing link front bracket,
go to the next step.*
5. Using the 3/16 in. x 9 in. flat punch and the 12-16-oz. hammer, strike the radius of the frame corners on each of the X-marked areas shown below.
Again, swing the hammer with a 10 to 12 inch stroke to be sure enough force is applied to the flat punch.
^ If the flat punch doesn't poke a hole in any of the X-marked areas, go to STAGE 3 REPAIR.
^ If the flat punch pokes a hole in any of the X-marked areas, go to STAGE 4 REPAIR.
Stage 1 Repair
STAGE 1 REPAIR
NOTE:
^ Do this repair on both sides of the vehicle.
^ Noxudol spray is highly flammable. Keep away from ignition sources (no smoking). Keep at a temperature not exceeding 120°F (50°C).
^ Wear hand and eye protection to avoid direct contact with the Noxudol spray. Spraying should be done in an area with adequate ventilation.