Passport EX 4WD V6-3165cc 3.2L DOHC MFI (2001)
![background image](/honda/passport_ex_4wd/v6-3165cc_3.2l_dohc_mfi/Page-1599002.png)
11. Remove ABS sensor ring.
12. Remove outer bearing.
13. Remove oil seal.
14. Remove inner bearing.
15. Remove bolt, if necessary, replace the wheel pin in the following manner.
-
Apply a scribe mark (1) to disc to hub.
-
Clamp the hub and disc assembly in a vise, using protective pads.
-
Remove the 6 disc-to-hub retaining bolts.
-
Place hub on a suitable work surface and remove the studs by using a hammer.
Inspection and Repair
Make necessary correction or parts replacement if wear, damage, corrosion or any other abnormal condition are found through inspection. Check the
following parts.
-
Hub
-
Hub bearing oil seal
-
Knuckle spindle
-
Disc
-
Caliper
-
Shift on the fly system parts (Cap, Hub flange, Shim, Snap ring)
-
ABS sensor ring
Reassembly