Passport EX 4WD V6-3165cc 3.2L DOHC MFI (2001)
5. Install 8.5 mm connector of ground wire under the head of this valve body bolt and reinstall it. Tighten the bolt to the specified torque (HEC).
Torque: 20 Nm (15 ft. lbs.)
6. Remove two guide pins from main case.
7. Install servo cover gasket, cover, and four 13 mm screws. Tighten the screws to the specified torque.
Torque: 25 Nm (18 ft. lbs.)
8. Connect wiring harness to band control and shift solenoids.
9. Install roller and spring assembly to manual detent.
Install two 13 mm screws, and tighten them to the specified torque.
Torque: 20 Nm (15 ft. lbs.)
10. Install oil filter and three 13 mm screws. Tighten to the specified torque.
Torque: 20 Nm (15 ft. lbs.)
11. Install oil pan gasket, magnet, oil pan and sixteen 10 mm screws. Tighten the screws to the specified torque.
Torque: 11 Nm (96 inch lbs.)
12. Fill transmission through overfill screw hole of oil pan, using ATF DEXRON III.
13. Connect battery ground cable.