Passport EX 4WD V6-3165cc 3.2L DOHC MFI (2001)
Transmission Temperature Sensor/Switch: Service and Repair
Transmission Oil Temperature Sensor (Main Case) (V6)
Removal
1. Raise the vehicle and support it on jack stands.
2. Disconnect battery ground cable.
3. Drain fluid.
4. Remove sixteen 10 mm main case oil pan fixing screws, main case oil pan, and gasket.
5. Disconnect wiring harness from shift solenoids, band apply solenoid, and 7 way connector of main case. Pull only on connectors, not on wiring
harness.
6. Remove wiring harness assembly with transmission oil temperature sensor.
Installation
1. Install wiring harness assembly with transmission oil temperature sensor to band apply solenoid, shift solenoids, and 7 way connector of main
case.
2. Install oil pan gasket, oil pan and sixteen 10 mm fixing screws. Tighten the screws to the specified torque.
Torque: 11 Nm (96 inch lbs.)
3. Fill transmission through the overfill screw hole of oil pan, using ATF DEXRON III.
4. Connect battery ground cable.