Passport LX 2WD V6-3.2L SOHC (6VD1) (1997)
7. Crankcase side bolts [9]
-
Cylinder block side bolts and tighten bolts in order to 39 Nm (29 ft. lbs.).
NOTE: Do not apply the oil to the bolts
8. Oil pump assembly [8]
-
Remove oil on cylinder block and oil pump mounting surface.
-
Apply sealant (TB1207B or equivalent) to the oil pump mounting surface.
-
Apply engine oil to seal lip.
-
Install oil pump in the cylinder block, and tighten fixing bolts to 18 Nm (13 ft. lbs.).
9. Oil strainer and rubber ring [7]
10. Oil pipe and rubber ring [6]
11. Oil pan [5]
-
Remove oil on oil pan mounting surface, and dry the surface.
-
Apply a proper wide bead of sealant (TB1207C or equivalent) to the oil pan mounting surface. The bead must be continuous. (Fig. 6A1-52)
-
Oil pan must be installed within 5 minutes after sealant application.
-
Tighten fixing bolts to 10 Nm (87 inch lbs.).
12. Timing belt [4]
13. Timing belt cover [3]
14. Crankshaft pulley [2]
-
Using special tool (J-8614-01,or equivalent), hold crankshaft pulley.
-
Tighten center bolt to 167 Nm (123 ft. lbs).