Passport LX 2WD V6-3.2L SOHC (6VD1) (1997)
Exhaust Manifold: Service and Repair
Left Hand Side
REMOVAL
NOTE: Battery ground cable
1. Air cleaner duct assembly
2. Exhaust Gas Recirculation pipe fixing bolts and gasket
-
Remove from exhaust manifold.
3. 3rd crossmember & transfer under cover
4. Exhaust front pipe
-
Remove three stud nuts and three bolts and nuts, then disconnect front pipe.
5. Heat protector
-
Remove five fixing bolts, then the heat protector.
6. Engine hanger
-
Remove bolt and nut, then engine hanger.
7. Exhaust manifold
-
Remove seven nuts and remove exhaust manifold from the engine.
INSTALLATION
1. Exhaust manifold [7]
-
Tighten nuts to 57 Nm (42 ft. lbs.) a with new ones.
2. Engine hanger [6]
3. Heat protector [5]
4. Exhaust front pipe [4]
-
Tighten three stud nuts and three bolts and nuts to:
-
Stud nuts 67 Nm (49 ft. lbs.).
-
Bolts and nuts 43 Nm (32 ft. lbs.).
5. 3rd crossmember & transfer under cover [3]
6. Exhaust Gas Recirculation pipe fixing bolts and gasket [2]
-
Tighten bolts to 28 Nm (21 ft. lbs.).
7. Air cleaner duct assembly [1]