Passport LX 2WD V6-3.2L SOHC (6VD1) (1997)
![background image](/honda/passport_lx_2wd/v6-3.2l_sohc_(6vd1)/Page-2092004.png)
2. Drive plate
-
Install the drive plate to the compressor drive shaft together with the original shim(s). Press the drive plate by hand.
1. Drive plate bolt
-
Using drive plate holder (J-33939) to prevent the drive plate from rotating.
-
Tighten the drive plate bolt to the specified torque.
Torque N.m (lb .in.) 13 (113)
-
After tightening the drive plate bolt, check to be sure the pulley rotates smoothly.
-
Check to be sure that the clutch clearance is between 0.3 - 0.6 mm (0.01 - 0.02 in.)
-
If necessary, install adjusting shim(s)
-
Adjusting shims are available in the following thickness.
Thickness
0.1 mm (0.0039 in.)
0.3 mm (0.0118 in.)
0.5 mm (0.0197 in.)