Passport LX 2WD V6-3.2L SOHC (6VD1) (1997)
Engine Control Module: Service and Repair
Wire Harness Repair
Twisted Shielded Cable
REMOVAL
1. Remove the outer jacket.
2. Unwrap the aluminum/MYLAR tape. Do not remove the MYLAR.
3. Untwist the conductors.
4. Strip the insulation as necessary.
INSTALLATION
1. Splice the wires using splice clips and rosin core solder.
2. Wrap each splice to insulate.
3. Wrap the splice with MYLAR and with the drain (uninsulated) wire.
4. Tape over the whole bundle to secure.
Twisted Leads
REMOVAL
1. Locate the damaged wire.
2. Remove the insulation as required.
INSTALLATION
1. Use splice clips and rosin core solder in order to splice the two wires together.
2. Cover the splice with tape in order to insulate it from the other wires.
3. Twist the wires as they were before starting this procedure.