Passport LX 2WD V6-3.2L SOHC (6VD1) (1997)
Shift Solenoid: Service and Repair
Adapter Case Valve Body
PREPARATION:
-
Disconnect negative (-) battery cable.
-
Drain fluid.
REMOVE:
1. Adapter case oil pan Remove twelve 10 mm screws, adapter case oil pan, and gasket.
NOTE: Oil pan still contains transmission fluid. Place a large drain container under the oil pan. Drain the fluid carefully.
2. Wiring harness. Disconnect wiring harness from force motor solenoid, converter clutch solenoid and 5 pin connector of adapter case. Pull only on
connectors, not on wiring harness.
3. Solenoid:
a. Remove 11 mm bolt and disconnect earth harness from converter clutch solenoid.
b. Remove converter clutch solenoid with two O-rings.
c. Remove 11 mm bolt, retainer, and force motor solenoid.
INSTALL:
NOTE: To install, follow the removal steps in the reverse order, noting the following points;
1. Solenoid:
a. Install force motor solenoid, retainer, and 11 mm bolt to adapter case valve body. Torque 10 Nm (87 inch lbs.).
b. Install converter clutch solenoid with two O-rings.
c. Install 6.5 mm connector of earth harness under the head of the converter clutch solenoid bolt.
d. Tighten 11 mm bolt to adapter case valve body.
-
Torque 10 Nm (87 inch lbs.).
2. Wiring harness. Connect wiring harness assembly to solenoids and 5 pin connector of adapter case.
3. Adapter case oil pan:
a. Install adapter case oil pan, new gasket, and twelve 10 mm screws.
-
Torque 11 Nm (96 inch lbs.).
b. Fill transmission through overfill screw hole oil pan, using ATF DEXRON-III. Connect negative (-) battery cable.