Passport LX 2WD V6-3.2L SOHC (6VD1) (1997)
1. Inspect the lower end boot for damage or grease leak. Move the ball joint as shown in the figure to confirm its normal movement.
2
Inspect screw/taper area of ball for flaws.
3. If any defects are found by the above inspections, replace the ball joint assembly with new one.
4. After moving the ball joint 4 or 5 times, attach nut then measure the preload. Starting torque to 0.5 - 3.2 Nm (0.4 - 2.4 ft. lbs.).
5. If the above limits specified are exceeded, replace the ball joint assembly.