Passport LX 2WD V6-3.2L SOHC (6VD1) (1997)
Bell Housing: Service and Repair
PREPARATION:
-
Remove engine hood.
-
Disconnect negative (-) battery cable.
REMOVE:
1. Transmission assembly. Remove transmission assembly with transfer case from the vehicle.
2. Torque converter. Remove torque converter from converter housing.
3. Oil seal ring:
a. Remove three screws.
b. Remove oil seal ring from converter housing.
INSTALL:
NOTE: To install, follow the removal steps in the reverse order, noting the following points;
3. Oil seal ring:
a. Apply clean ATF to the new oil seal ring lip.
b. Install oil seal ring to converter housing.
-
Torque 3 Nm (26 inch lbs.).
2. Torque converter. Install torque converter to converter housing.
1. Transmission assembly:
a. Install transmission assembly with transfer case to the vehicle.
b. Connect negative (-) battery cable.
c. Install engine hood.
d. Adjust shift lock cable. See: Shift Linkage/Shift Cable
e. Inspect transmission fluid level. See: Fluid - A/T