Passport LX 2WD V6-3.2L SOHC (6VD1) (1997)
Transmission Fluid (TFT) Temperature Sensor: Service and Repair
REMOVAL
Preparation:
^
Disconnect negative (-) battery cable.
^
Drain fluid.
1. Adapter case oil pan. Remove twelve 10 mm screws, adapter case oil pan and gasket.
NOTE: Oil pan still contains transmission fluid. Place a large drain container under the oil pan. Drain the fluid carefully.
2. Wiring harness:
a. Disconnect wiring harness from force motor solenoid, converter clutch solenoid and 5 pin connector of adapter case. Pull only on connectors,
not on wiring harness.
b. Remove wiring harness assembly (transmission oil temperature sensor).
INSTALLATION
NOTE: To install, follow the removal steps in the reverse order, noting the following points;
1. Wiring harness. Install harness assembly to converter clutch solenoid, force motor and 5 pin connector of adapter case.
2. Adapter case oil pan:
a. Install oil pan gasket, oil pan and twelve 10 mm screws.
^
Torque 11 Nm (96 inch lbs.).
b. Fill transmission through the overfill screw hole of oil pan, using ATF DEXRON-III.
c. Connect negative (-) battery cable.