Passport LX 2WD V6-3.2L SOHC (6VD1) (1997)
Carrier Bearings: Testing and Inspection
AXLE HOUSING
-
The carrier bore for nicks or burrs that would prevent the outer diameter of the pinion seal from sealing. Remove any burrs that are found.
-
The bearing cap bores for nicks or burrs. Remove any burrs that are found.
-
The housing for cracks. Replace the housing if any cracks are found.
-
The housing for foreign material such as metal chips, dirt, or rust.
DIFFERENTIAL
-
Pinion gear shaft for unusual wear.
-
Pinion gear and side gear teeth for wear, cracks, scores, and spelling.
-
Thrust washers for wear.
-
The fit of the differential side gears in the differential case.
-
The fit of the side gears on the axle shafts.
-
Differential case for cracks and scores.
-
Replace all worn parts.
PINION AND RING GEAR
-
Pinion and ring gear teeth for cracking, chipping, scoring, or excessive wear.
-
Pinion splines for wear.
-
Pinion flange splines for wear.
-
The sealing surface of the pinion flange for nicks, burrs, or rough tool marks which would cause damage to the seal's inside diameter and result in
an oil leak.
-
Replace all worn or broken parts.
-
Ring and pinion gears are matched sets and are both replaced anytime a replacement of either is necessary.