Passport LX 2WD V6-3.2L SOHC (6VD1) (1997)
Intermediate Plate: Service and Repair
Inspection
INSPECTION AND REPAIR
Make the necessary adjustments, and part replacements if excessive wear or damage is discovered during inspection
Shift Arm Thickness
Use a micrometer to measure the shift arm thickness. If the measured value is less than the specified limit, the shift arm must be replaced.
STANDARD:
-
1st-2nd: 9.60-9.85mm (0.378-0.388 inch)
-
3rd-4th/Rev-5th: 9.60-9.85mm (0.378-0.388 inch)
LIMIT: 9.0mm (0.354 inch)
Detent Spring Free Length
Use a vernier caliper to measure the detent spring free length. If the measured value is less than the specified limit, the detent spring must be
replaced. Detent spring free length:
-
Standard 26.8 mm (1.06 inch).
-
Limit 26.2 mm (1.03 inch).
Detent Spring Tension
Use a spring tester to measure the valve spring tension. If the measured value is less than the specified limit, the detent spring must be replaced.
Compressed Height: 20mm (0.787 inch)
Tension (standard): 87.2-97.1 N (19.6-21.8 lb.)