Passport LX 2WD V6-3.2L SOHC (6VD1) (1997)
/Page-1625002.png)
3. Shift fork:(2)
a. Apply grease to the pin hole inner circumferences end thrust surfaces.
b. Attach the shift fork to the fulcrum bridge by inserting the shift fork pin from the bottom side of the fulcrum bridge.
c. Install the washer and snap pin.
4. Release bearing:(1)
a. Apply grease to the areas shown.
b. Install the release bearing to the shift fork in the proper direction.
NOTE: Ensure release bearing is properly positioned during installation.
