Passport LX 4WD V6-3.2L DOHC (6VD1) (2000)
/Page-1129004.png)
SMART CABLE DIAGNOSIS
If the red light (# 3) on the Smart Cable came on or was flashing while updating the PCM, do this:
*1.
If not already done, load the May 1999 or later DOS CD onto your DOS workstation. Loading instructions were included in the CD'S mailing.*
2.
Disconnect the Smart Cable from the vehicle's DLC.
*3.
Connect the Smart Cable to the DOS workstation (see steps 2 and 3 of REPROGRAMMING A SMART CABLE).*
4.
Connect the 110 VAC/12 VAC power supply to the Smart Cable box and to 110 VAC power.
*5.
Log in to HONDANET 2000.
6.
From the choices across the top of the HONDANET 2000 screen, click on Service Bay, and then click on Smart Cable from the drop-down menu.
7.
Click on View Err at the bottom of the screen to display the problem encountered while the Smart Cable was connected to the vehicle.
SMART CABLE ASSISTANCE
For questions when loading the DCS CD, contact the HONDANET 2000 Support Center at 800-245-4343.
For questions or problems on Smart Cable hardware and Smart Cable usage, contact American Honda Special Tools at 800-345-8327.*
Disclaimer
