Passport LX 4WD V6-3.2L DOHC (6VD1) (2000)
20. Install the passenger's side type A reinforcement bracket using the hardware in the kit:
Install the trailing link front mounting nut and bolt hand-tight, then torque the remaining bolts and nuts, in the order shown on the illustration below:
^ Torque the bracket bolts to 35 Nm (25 Ib-ft).
^ Torque the body mount stud and nut to 30 Nm (22 Ib-ft).
21. Remove the driver's side lower trailing link front mounting bolt:
^ Push the bolt out toward the fuel tank as far as possible.
^ Cut off the bolt head with a reciprocating saw.
^ Push the bolt out through the opposite side of the bracket.
22. * Install the driver's side type A reinforcement bracket using the hardware in the kit. The required parts vary, depending on the vehicle model year
and frame design. To correctly install the driver's side type A reinforcement bracket, use the illustrations below for reference.*
All 1998-99 models and some 2000 models require three bolts and one body mount stud and nut; some 2000 models require three bolts, one body mount
stud and nut, plus one washer; all 2001-02 models require three bolts, one body mount stud and nut, plus one fuel tank protector bolt.