Passport LX 4WD V6-3165cc 3.2L DOHC MFI (2001)
7. Remove control level assembly.
8. Disconnect control cables at each unit side.
Installation
To install, follow the removal steps in the reverse order, noting the following points:
1. Adjust the control cable
-
Temperature control cable.
1. Turn the control knob to the left ("MAX COLD" position).
2. Connect the control cable at the "COLD" position of the temperature control link of the heater unit and secure it with the clip.
-
Air select control cable
1. Turn the control knob to the right ("DEFROST" position).
2. Connect the control cable at the "DEFROST" position of the mode control link of the heater unit and secure it with the clip.
2. Check the control cable operation.