Passport LX 4WD V6-3165cc 3.2L DOHC MFI (2001)
6. Install the drive plate to the compressor drive shaft together with the original shim(s) (1). Press the drive plate by hand.
7. Install drive plate bolt by using drive plate holder J-33939 (1) to prevent the drive plate from rotating.
-
Tighten the drive plate bolt to the specified torque.
Torque: 13 N.m (113 lb in)
-
After tightening the drive plate bolt, check to be sure the pulley rotates smoothly.
-
Check to be sure that the clutch clearance is between 0.3 - 0.6 mm (0.01 - 0.02 in.)
-
If necessary, install adjusting shim(s).
-
Adjusting shims are available in the following thickness.