Passport LX 4WD V6-3165cc 3.2L DOHC MFI (2001)
REMOVAL
1. Raise the vehicle and support the frame with suitable safety stands.
2. Remove wheel and tire assembly.
3. Remove bolt and nut.
4. Remove link.
CAUTION: Be careful not to damage the ball joint boot.
5. Remove bracket.
6. Remove rubber bushing.
INSPECTION AND REPAIR
Make necessary correction or parts replacement if wear, damage, corrosion or any other abnormal condition are found through inspection.
Check the parts:
-
Stabilizer bar
-
Rubber bushing
-
Link
INSTALLATION
1. Install rubber bushing.
2. Install bracket to axle housing and tighten to the specified torque.
Torque: 25 Nm (119 ft. lbs.)
3. Install link.