Passport LX 4WD V6-3165cc 3.2L DOHC MFI (2001)
Quarter Window Glass: Service and Repair
Quarter Glass
Rear Quarter Glass (LWB)
Rear Quarter Glass (LWB) - Parts Locations
Removal
1. Disconnect the battery ground cable.
2. Remove the rear quarter trim panel.
3. Remove the rear quarter glass.
Installation
1. Rear quarter glass.
-
Clean the bonding surfaces of both the glass and the body panel.
-
Be absolutely sure to apply glass primer to the side glass.
-
Be absolutely sure to apply body primer fully to the body.
NOTE: Immediately wipe off the primer left on the body or extruded sealant.
-
Attach the fastener to the indicated position of body with sealant as shown in the figure.
-
Apply the sealant to the circumference of glass as shown in the figure.
-
Insert the location pins on glass into the panel, push the glass against the panel, and bond them.
-
Attach the molding to the body with sealant.
-
Cure the bonding at a temperature of 20 °C - 30 °C (68 °F - 86 °F) for 24 hours.
-
Check the rear quarter glass for any signs of water leak
2. Install the rear quarter trim panel.