Pilot V6-3.5L (2004)
2. Remove the vacuum hoses (A) and breather pipe (B), then remove the intake air duct (C).
3. Remove the throttle cable (A) and cruise control cable (B) by loosening the locknuts (C), then slipping the cable ends out of the accelerator
linkage. Take care not to bend the cables when removing them. Always replace any kinked cable with a new one.
4. Remove the engine wire harness connectors and wire harness clamps from the intake manifold.
-
Intake air temperature (IAT) sensor connector
-
Idle air control (IAC) valve connector
-
Throttle position (TP) sensor connector
-
Manifold absolute pressure (MAP) sensor connector
-
Evaporative emission (EVAP) canister purge valve connector
5. Remove the brake booster vacuum hose (A) and positive crankcase ventilation (PCV) hose (B).