Pilot V6-3.5L (2004)
A/C Signal: Testing and Inspection
A/C Signal Circuit Troubleshooting
1. Turn the ignition switch OFF.
2. Disconnect the A/C pressure switch 2P connector.
3. Turn the ignition switch ON (II).
4. Measure voltage between PCM connector terminals A27 and B20.
Is there about 5 V or battery voltage?
YES - Go to step 5.
NO - Go to step 12.
5. Turn the ignition switch OFF.
6. Reconnect the A/C pressure switch 2P connector.
7. Turn the ignition switch ON (II).
8. Momentarily connect PCM connector terminals A17 and B20 with a jumper wire several times.
Is there a clicking noise from the A/C compressor clutch?
YES - Go to step 9.
NO - Go to step 15.
9. Start the engine.
10. Turn the blower switch ON.
11. Turn the A/C switch ON.
Does the A/C operate?
YES - The air conditioning signal is OK.
NO - Go to step 16.
12. Turn the ignition switch OFF.
13. Disconnect PCM connector A (32P).