Pilot V6-3.5L (2004)
8. Insert a 6.0 mm (0.24 inch) pin (A) into the positioning hole (B) on the detent plate through the positioning hole (C) on the control bracket. The
shift lever is secured in the [N] position.
9. Align the socket holder (A) on the shift cable (B) with the slot in the shift cable bracket (C), then slide the holder into the bracket. Install the shift
cable end (D) over the mounting stud (E) by aligning its square hole (F) with the square fitting (G) at the bottom of the stud. Rotate the holder a
quarter turn to secure the shift cable. Do not install the shift cable by twisting the shift cable guide (H) and damper (I).
10. Verify that the shift cable end (A) is properly installed on the mounting stud (B).
11. If improperly installed, remove the shift cable from the shift cable bracket, and reinstall the shift cable. Do not install the shift cable end on the
mounting stud while the shift cable is on the shift cable bracket.