Pilot V6-3.5L (2004)
4. Remove the snap ring (A).
5. Make a mark (B) on the spider (C) and driveshaft (D) to identify the position of the spider on the shaft.
6. Remove the spider.
7. Remove the circlip (A).
8. Make a mark (B) on the bearing retainer (C) and inboard joint (D) to identify the locations of ball bearing and grooves in the inboard joint. Then
remove the inboard joint on the shop towel (E). Be careful not to drop the ball bearings when separating them from the inboard joint.
9. Remove the snap ring (A).
10. Make a mark (B) on the bearing retainer (C), the bearing race (D) and driveshaft (E) to identify the position of the bearing retainer and the bearing
race on the shaft.
11. Remove the bearing race and the steel ball bearings (F).